Cranioplasty with split lateral skull plate segments for reconstruction of skull defects

This paper reports the use of cranioplasty using segments of split lateral skull plate to correct large skull defects (larger than 8 x 8 cm). The subjects consisted of 10 patients with head trauma who had undergone decompression surgery, and two patients who had undergone tumour resection. Bone grafts were obtained by cutting approximately 2 cm wide strips from the lateral skull plate using a bone saw that was inserted from a free margin of the bone defects. By cutting strips laterally from the bone defect, the necessary amount of split lateral skull plate can be obtained without performing craniotomy. The pieces of split lateral skull plate are then fixed to the defect using wire or titanium mini-plates. At this point, the selection of bone grafts that match the curvature of the dura mater is important, so that no dead spaces are created between the dura mater and the bone grafts. Infection was not detected in any of the 12 patients, and all bone grafts took completely. One of the 12 patients suffered from a pathological fracture and bone resorption 6 months after surgery. The fracture occurred because the use of basket-shaped reconstruction plates resulted in large spaces between the plate segments, and in addition the intracranial pressure was kept low by a V-P shunt, thus rendering the patient more vulnerable to atmospheric pressure.