Surface exposure of the methionine side chains of calmodulin in solution. A nitroxide spin label and two-dimensional...

Binding of calcium to calmodulin (CaM) causes a conformational change in this ubiquitous calcium regulatory protein that allows the activation of many target proteins. Met residues make up a large portion of its hydrophobic target binding surfaces. In this work, we have studied the surface exposure of the Met residues in the apo- and calcium-bound states of CaM in solution. Complexes of calcium-CaM with synthetic peptides derived from the CaM-binding domains of myosin light chain kinase, constitutive nitric-oxide synthase, and CaM-dependent protein kinase I were also studied. The surface exposure was measured by NMR by studying the effects of the soluble nitroxide spin label, 4-hydroxyl-2,2,6, 6-tetramethylpiperidinyl-1-oxy, on the line widths and relaxation rates of the Met methyl resonances in samples of biosynthetically 13C-methyl-Met-labeled CaM. The Met residues move from an almost completely buried state in apo-CaM to an essentially fully exposed state in Ca2+4-CaM. Binding of two Ca2+ to the C-terminal lobe of CaM causes full exposure of the C-terminal Met residues and a partial exposure of the N-terminal Met side chains. Binding of the three target peptides blocks the access of the nitroxide surface probe to nearly all Met residues, although the mode of binding is distinct for the three peptides studied. These data show that calcium binding to CaM controls the surface exposure of the Met residues, thereby providing the switch for target protein binding.