Related Experiment Video

Updated: Aug 13, 2026

Fracture Apparatus Design and Protocol Optimization for Closed-stabilized Fractures in Rodents
06:59

Fracture Apparatus Design and Protocol Optimization for Closed-stabilized Fractures in Rodents

Published on: August 14, 2018

Reuse of Ilizarov frame components: a potential cost savings?

F J Kummer1, V H Frankel, M A Catagni

  • 1Department of Orthopaedics, Hospital for Joint Diseases Orthopaedic Institute, New York.

Contemporary Orthopaedics
|July 7, 1992
PubMed

More Related Videos

C-arm-Free Simultaneous OLIF51 and Percutaneous Pedicle Screw Fixation in a Single Lateral Position12:25

C-arm-Free Simultaneous OLIF51 and Percutaneous Pedicle Screw Fixation in a Single Lateral Position

Published on: September 16, 2022

Rapid Formation and Testing of Self-expanding NiTi Frames with a Small Form Factor Suitable for Minimally Invasive Implants06:48

Rapid Formation and Testing of Self-expanding NiTi Frames with a Small Form Factor Suitable for Minimally Invasive Implants

Published on: March 7, 2025

Related Concept Videos

Frames01:30

Frames

Frames are essential components of various mechanical and structural systems used daily. These structures are known for their stability and ability to bear heavy loads. A frame is constructed using two-force and multi-force members, interconnected using pin joints. In contrast, trusses are made entirely of two-force members.
Frames are versatile and widely used in various applications such as structural supports for beams and columns, automobile chassis construction, and in the construction...
Frames: Problem Solving I01:24

Frames: Problem Solving I

Consider a jib crane with an external load suspended from the pulley. The dimensions of the crane members are shown in the figure. A systematic analysis of the frame structure is required to determine the reaction forces at the pin joints, assuming that the pulleys are frictionless.
Deformation of Member under Multiple Loadings01:11

Deformation of Member under Multiple Loadings

When a rod is made of different materials or has various cross-sections, it must be divided into parts that meet the necessary conditions for determining the deformation. These parts are each characterized by their internal force, cross-sectional area, length, and modulus of elasticity. These parameters are then used to compute the deformation of the entire rod.
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...