Related Experiment Videos
Two-body sliding wear of a direct-filling silver alternative to amalgam
H H Xu1, A A Giuseppetti, F C Eichmiller
1Paffenbarger Research Center, American Dental Association Health Foundation, National Institute of Standards and Technology, Gaithersburg, Maryland 20899, USA. hockin.xu@nist.gov
Objective:
This study investigated the wear resistance of a mercury-free silver direct-filling material and a dental amalgam.
Method And Materials:
A precipitated silver powder was rinsed with dilute fluoboric acid and consolidated into a cohesive solid. For tooth cavity restoration and flexural testing, the silver was consolidated with a dental amalgam plugger at a load of 15 N. For wear testing, because of the relatively large specimen size, the silver was pressed at a pressure of 150 MPa, yielding a density similar to that obtained by hand consolidation.
Results:
The silver had a flexural strength twice that of amalgam. Pin-on-disk wear resulted in a smooth surface and hardening in silver, as measured by indentation inside the wear tracks, in contrast to the damage that was found in amalgam. The wear track cross-sectional area (n = 12) at 10(6) revolutions was not statistically significantly different among amalgam, polished silver, and burnished silver.
Conclusion:
The consolidated silver exhibited work hardening and surface densification during wear and, as a result, was more resistant to wear-induced damage than amalgam.