The pentaene macrolide antibiotic filipin prefers more rigid DPPC bilayers: a fluorescence pressure dependence study

Filipin is a pentaene macrolide antibiotic which was previously shown to incorporate more extensively into DPPC bilayers below the main phase transition temperature than above this temperature. This result was extremely unusual because drugs tend to be expelled from ordered gel phases. However, such results could not be safely attributed to the phase change of the bilayer itself because the temperature was changing concomitantly. In this work we changed the bilayer phase isothermally (53 degrees C) by hydrostatic pressure variation and discovered that filipin has a slightly more extensive incorporation in the pure DPPC gel phase (P>ca. 54.4 MPa): Kp,lc approximately 3x10(3) vs. Kp,gel approximately 6x10(3). The presence of sterols (45% molar ergosterol or cholesterol) caused an increase in the partition coefficients, regardless of pressure, ergosterol having a more pronounced effect (Kp approximately 2x10(4)-6x10(4)). Kp was pressure dependent in both cases, but mainly with cholesterol (Kp approximately 2x10(3)-2x10(4)). At variance with cholesterol, when ergosterol was used, no phase transition was detected. This difference cannot be due to a more extended uptake of filipin by cholesterol-containing membranes, and so must be due to specific interactions with cholesterol. In agreement with this finding, we discovered that filipin is more tightly packed (lower partial molar volume) in the cholesterol-rich phase than in the ergosterol-rich phase. Our results also point to a 2:1 DPPC:cholesterol stoichiometry in the cholesterol-rich phase (17% molar cholesterol). All partition coefficients were calculated from steady-state fluorescence anisotropy measurements.