Influence of different etching times on hybrid layer formation and tensile bond strength

To correlate the thickness of the dentin/resin hybrid layer and the influence of different etching times to the composite resin tensile bond strength.

775 human molars were prepared by removing the occlusal cusps to expose middle dentin using a microtome saw. Five commercially available dentin bonding agents were applied according to the manufacturers' instructions. Only the etching times were varied. For confocal laser scanning microscopy (CLSM) measurements, 325 teeth were used and the etching times were varied (not etched, 15, 30, 60 or 120 seconds). The primer components or self-priming adhesive, respectively, were fluorescence-labeled by rhodamine B isothiocyanate. In each case, the prepared surfaces were then covered by a layer of composite resin, sectioned and examined using a CLSM in fluorescent mode. The extension of hybrid layers was quantified by measuring the distances between the dentin-composite junction to a visible boundary. For the tensile bond strength measurements (Zwick testing machine), 450 molars were prepared, using different dentin etching times (not etched, 15, 30, 60, 120 and 180 seconds).

A hybrid layer was found in all etched teeth. The CLSM data gave evidence for an exponent-function relationship between the periods of etching and the thickness of the hybrid layer. The highest tensile bond strengths were achieved after 15 s of etching, followed by 30 s and 60 s. Under these etching conditions and irrespective of the bonding agent, bond strengths were significantly higher (P < or = 0.05) than without etching or after 120 and 180 s of etching. There was no linear correlation between the thickness of the hybrid layer and the bond strength.