Conformational epitope of the type III group B Streptococcus capsular polysaccharide

The protective epitope of the type III group B streptococcal polysaccharide (GBSPIII) is length dependent and conformational. To obtain a more accurate characterization of the conformational epitope, ELISA inhibition and surface plasmon resonance studies were conducted on two GBSPIII-specific mAbs using a large panel of oligosaccharide probes. The results of the studies confirmed that 2 repeating units (RU) is the minimum binding unit and that, while increases in chain length from 2 RU to 7 RU caused further optimization of the epitope, it remained monovalent. A 3-fold increase in affinity was observed between 7 RU and 20 RU, which, by surface plasmon resonance studies on a Fab, was shown to be due to both further optimization of the individual epitope and the occurrence of multivalency of epitope. The data support our hypothesis that the conformational epitope is an extended helical segment of the GBSPIII. GBSPIII exists mainly in the random coil form, which structurally mimics short oligosaccharide self Ags, but it can infrequently and spontaneously form extended helices. Although not prevalent in GBSPIII, the immune system preferentially selects these helical epitopes because they are unique to the polysaccharide. Contrary to a previously proposed model of GBSPIII binding in which the binding of the first Ab propagates a continuum of helical epitopes, our binding kinetics are consistent only with the helical epitope's being discontinuous and infrequent.