An Australian study to evaluate worker exposure to chrysotile in the automotive service industry

A study was conducted in Sydney, Australia, in 1996 to investigate the current exposure levels, control technologies, and work practices in five service garages (four car and one bus), three brake bonding workshops, and one gasket processing workshop. This study formed part of the assessment of chrysotile as a priority existing chemical under the Australian National Industrial Chemicals Notification and Assessment Scheme. A total of 68 (11 personal and 57 area) air samples were collected, in accordance with the Australian standard membrane filter method. Fiber concentrations were determined by the traditional phase contrast microscopy (PCM) method and 16 selected samples were analyzed by the more powerful transmission electron microscopy (TEM). Chrysotile exposure of car mechanics measured by PCM was typically below the reportable detection limit of 0.05 f/mL, irrespective of whether disc brake, drum brake, or clutch was being serviced. These low levels can be attributed to the wet cleaning or aerosol spray methods used in recent years to replace the traditional compressed air jet cleaning. In the three brake shoe relining workshops, task-specific exposure reached up to 0.16 f/mL in the processes of cutting and radius grinding. TEM results were generally higher, due to its higher resolution power. The median diameter on samples taken from the service garages (passenger cars), as determined by TEM, was 0.5-1.0 micron; and was between 0.2-0.5 micron for the brake bonding and gasket processing workshops, while that for the bus service depot was 0.1-0.2 micron. Most of the respirable fibers (84%, mainly forsterite) from the bus service depot were below 0.2 micron in diameter which is the resolution limit of PCM. In the brake bonding and gasket cutting workshops, 34 percent and 44 percent of the chrysotile fibers were below 0.2 micron in diameter.