Guided waves by axisymmetric and non-axisymmetric surface loading on hollow cylinders

Related Experiment Video

Updated: Oct 19, 2026

Visualization of Flow Field Around a Vibrating Pipeline Within an Equilibrium Scour Hole
00:09

Visualization of Flow Field Around a Vibrating Pipeline Within an Equilibrium Scour Hole

Published on: August 26, 2019

Shin1, Rose

  • 1Department of Engineering Science and Mechanics, The Pennsylvania State University, University Park 16801, USA.

Ultrasonics
|September 28, 1999
PubMed

More Related Videos

Impacts of Free-falling Spheres on a Deep Liquid Pool with Altered Fluid and Impactor Surface Conditions08:49

Impacts of Free-falling Spheres on a Deep Liquid Pool with Altered Fluid and Impactor Surface Conditions

Published on: February 17, 2019

Investigating the Three-dimensional Flow Separation Induced by a Model Vocal Fold Polyp09:58

Investigating the Three-dimensional Flow Separation Induced by a Model Vocal Fold Polyp

Published on: February 3, 2014

Related Concept Videos

Thin-Walled Hollow Shafts01:15

Thin-Walled Hollow Shafts

In analyzing a thin-walled hollow shaft subjected to torsional loading, a segment with width dx is isolated for examination. Despite its equilibrium state, this segment faces torsional shearing forces at its ends. These forces are quantitatively described by the product of the longitudinal shearing stress on the segment's minor surface and the area of this surface, leading to the concept of shear flow. This shear flow is consistent throughout the structure, indicating a uniform distribution of...
Eccentric Axial Loading in a Plane of Symmetry01:16

Eccentric Axial Loading in a Plane of Symmetry

Eccentric axial loading occurs when an axial load is applied away from the centroidal axis of a structural member. This scenario is common in engineering, where structural elements may not be directly aligned due to various design or functional requirements.
Hydrostatic Pressure Force on a Curved Surface01:04

Hydrostatic Pressure Force on a Curved Surface

Hydrostatic pressure on curved surfaces is a fundamental concept in fluid mechanics with broad applications in the civil engineering field. When fluid is in contact with a curved surface, as in a reservoir, dam, or storage tank, it exerts pressure that varies in magnitude and direction along the curved surface. To assess the total hydrostatic force exerted by the fluid on a curved structure, engineers typically isolate the fluid volume adjacent to the surface and analyze the forces acting on...
Load along a Single Axis01:29

Load along a Single Axis

In structural engineering, the analysis of beams subjected to varying loads is a critical aspect of understanding the behavior and performance of these structural elements. A common scenario involves a beam subjected to a combination of different load distributions.
Consider a beam of length L subjected to a varying load, which is a combination of parabolic and trapezoidal load distribution along the x-axis. In this case, it is essential to determine the resultant loads, their locations, and...
Unsymmetric Loading of Thin-Walled Members01:23

Unsymmetric Loading of Thin-Walled Members

Thin-walled members with non-symmetrical cross-sections are vital to engineering structures, offering material efficiency and structural integrity. However, unsymmetrical loading on these members leads to complex stress distributions, resulting in simultaneous bending and twisting can cause deformation or structural failure. The interaction between bending and twisting requires detailed analysis to ensure structural resilience.
The concept of the shear center is crucial in countering the...
Deformation in a Circular Shaft01:10

Deformation in a Circular Shaft

One of the distinctive characteristics of circular shafts is their ability to maintain their cross-sectional integrity under torsion. In other words, each cross-section continues to exist as a flat, unaltered entity, simply rotating like a solid, rigid slab. To understand the distribution of shearing stress within such a shaft, consider a cylindrical section inside this circular shaft. This section has a length of L and a radius of R, with one end fixed. The radius of the cylindrical section is...