Related Experiment Video
Updated: Oct 19, 2026

Synthesis of Wavelength-shifting DNA Hybridization Probes by Using Photostable Cyanine Dyes
Published on: July 6, 2016
Design, synthesis, and evaluation of a novel sequence-selective epoxide-containing DNA cross-linking agent based on
S C Wilson1, P W Howard, S M Forrow
1CRC Gene Targeted Drug Design Research Group, School of Pharmacy and Biomedical Sciences, University of Portsmouth, St. Michael's Building, White Swan Road, Portsmouth, Hants. PO1 2DT, U.K.
Abstract:
Synthetic routes have been investigated to prepare a novel C8-epoxide-functionalized pyrrolo[2,1-c][1,4]benzodiazepine 6 as a potential sequence-selective DNA cross-linking agent (Wilson et al. Tetrahedron Lett. 1995, 36, 6333-6336). A successful synthesis was accomplished via a 10-step route involving a pro-N10-Fmoc cleavage method that should have general applicability to other pyrrolobenzodiazepine (PBD) molecules containing acid- or nucleophile-sensitive groups. During the course of this work, a one-pot reductive cyclization procedure for the synthesis of PBD N10-C11 imines from nitro dimethyl acetals was also discovered, although this method results in C11a racemization which can reduce DNA binding affinity and cytotoxicity. The target epoxide 6 was shown by thermal denaturation studies to have a significantly higher DNA-binding affinity than the parent DC-81 (3) or the C8-propenoxy-PBD (15), which is structurally similar but lacks the epoxide moiety. The time course of effects upon thermal denaturation indicated a rapid initial binding phase followed by a slower phase consistent with the stepwise cross-linking of DNA observed for a difunctional agent. This was confirmed by an electrophoretic assay which demonstrated efficient induction of interstrand cross-links in plasmid DNA at concentrations >1 microM. Higher levels of interstrand cross-linking were observed at 24 h compared to 6 h incubation. A Taq polymerase stop assay indicated a preference for binding to guanine-rich sequences as predicted for bis-alkylation in the minor groove of DNA by epoxide and imine moieties. The pattern of stop sites could be partly rationalized by molecular modeling studies which suggested low-energy models to account for the observed binding behavior. The epoxide PBD 6 was shown to have significant cytotoxicity (45-60 nM) in the A2780, CH1, and CH1cis(R) human ovarian carcinoma cell lines and an IC(50) of 0.2 microM in A2780cis(R). The significant activity of 6 in the cisplatin-resistant CH1cis(R) cell line (IC(50) = 47 nM) gave a resistance factor of 0.8 compared to the parent cell line, demonstrating no cross-resistance with the major groove cross-linking agent cisplatin.
More Related Videos
14:11Synthesis of pH Dependent Pyrazole, Imidazole, and Isoindolone Dipyrrinone Fluorophores using a Claisen-Schmidt Condensation Approach
Published on: June 10, 2021
10:05Genome-wide Mapping of Drug-DNA Interactions in Cells with COSMIC (Crosslinking of Small Molecules to Isolate Chromatin)
Published on: January 20, 2016
Related Concept Videos
Base-Catalyzed Ring-Opening of Epoxides
Acid-Catalyzed Ring-Opening of Epoxides
Preparation of Epoxides
Epoxides result from alkene oxidation, which can be achieved by a) air, b) peroxy acids, c) hypochlorous acids, and d) halohydrin cyclization.
Epoxidation with Peroxy Acids
Epoxidation of alkenes via oxidation with peroxy acids involves the conversion of a carbon–carbon double bond to an epoxide using the oxidizing agent meta-chloroperoxybenzoic acid, commonly known as MCPBA. Since the O–O bond of peroxy acids is very weak, the addition of electrophilic oxygen of peroxy acids to...
Maxam-Gilbert Sequencing
Challenges of the Maxam-Gilbert Method
The...
Structure and Nomenclature of Epoxides
Diels–Alder Reaction Forming Bridged Bicyclic Products: Stereochemistry