Contractile properties of rabbit psoas muscle fibres inhibited by beryllium fluoride

The structure of truncated, recombinant Dictyostelium myosin motor domain complexed with Mg.ADP and slowly dissociating analogues of Pi has previously been characterized as two main states (S1-MgADP plus BeFx vs. A1F4- or Vi). The BeFx bound state is thought to mimic the weak actin-binding M.ATP complex, while the states with A1F4- or Vi bound mimic the M.ADP.Pi state. While the effects of A1F4- and Vi on fibre mechanics have been previously described (Chase et al., 1994, 1993), the effects of BeFx have not been characterized in detail. At pCa 4.5 (12 degrees C), we measured (i) steady-state isometric tension, (ii) stiffness (KS; 1 kHz sinusoids), and (iii) unloaded shortening velocity (Vu; slack test) in single skinned muscle fibres from rabbit psoas. Results were compared when tension was inhibited with either BeFx or 2,3-butanedione-monoxime (BDM) or modulated by altering myoplasmic [Ca2+]. With 3 mM total fluoride, 1 mM BeFx inhibited both tension and KS by approximately 50% (compared to 7-10 mM BDM and 50-100 microM A1F4-). Increasing [BeFx] to 10 mM further reduced tension to approximately 15% P0, but had little further effect on KS; with BDM and altered [Ca2+], KS scaled more proportionately with tension. Inhibition of tension and KS by BeFx was more rapidly reversible, compared with slow recovery from tension inhibition with A1F4- or Vi. Vu exhibited a complex dependence on [BeFx], being relatively unaffected by concentrations < or = 1 mM, and becoming inhibited steeply for [BeFx] above this level. With BDM, Vu co-varied more directly with force. Our results suggest that BeFx may induce a different cross-bridge state in fibres than do A1F4- or Vi, but all three analogues of Pi form complexes that mimic crossbridge states that follow ATP hydrolysis.