Effect of SiC reinforcement on the deformation and fracture micromechanisms of Al-Li alloys

The effect of SiC reinforcement on the microstructure of a naturally aged 8090 Al alloy as well as on the deformation and fracture micromechanisms was investigated. To this end, the microstructural characteristics (grain and reinforcement morphology, precipitate structure) were determined in the unreinforced alloy and in the composite reinforced with 15 vol.% SiC particles. The materials were tested under monotonic tension and fully reversed cyclic deformation and then carefully analysed through scanning and transmission electron microscopy to find the dominant deformation and failure processes for each material and loading condition. It was found that the dispersion of the SiC particles restrained the formation of elongated grains during extrusion and inhibited the precipitation of Al3Li. As a result, the plastic deformation in the composite was homogeneous, while strain localization in slip bands was observed in the unreinforced alloy specimens tested in tension and in fatigue. The unreinforced alloy failed by transgranular shear along the slip bands during monotonic deformation, whereas fracture was initiated by grain boundary delamination, promoted by the stress concentrations induced by the slip bands, during cyclic deformation. The fracture of the composite was precipitated by the progressive fracture of the SiC reinforcements during monotonic and cyclic deformation.