Related Experiment Video
Updated: Oct 18, 2026

Imaging In-Stent Restenosis: An Inexpensive, Reliable, and Rapid Preclinical Model
Published on: September 14, 2009
Duplex ultrasonography in assessing restenosis of renal artery stents
J Bakker1, J J Beutler, O E Elgersma
1Department of Radiology, University Hospital Utrecht, Heidelberglaan 100, 3584 CX Utrecht, The Netherlands.
Purpose:
To determine the accuracy and optimal threshold values of duplex ultrasonography (US) in assessing restenosis of renal artery stents.
Methods:
Twenty-four consecutive patients with 33 renal arteries that had previously been treated with placement of a Palmaz stent underwent duplex US prior to intraarterial digital subtraction angiography (DSA), which was the reference standard. Diagnostic accuracy of in-stent peak systolic velocity (PSV) and reno-aortic ratio (RAR = PSV renal stent/PSV aorta) in detecting > 50% in-stent restenosis were evaluated by the receiver operating characteristic curve. Sensitivity and specificity were determined using the optimal threshold values, and using published threshold values: RAR > 3.5 and in-stent PSV > 180 cm/sec.
Results:
Six examinations were technically inadequate. Nine stents had residual or restenosis > 50% at DSA. The two duplex parameters were equally accurate since areas under the curves were similar (0.943). With optimal threshold values of 226 cm/sec for PSV and 2.7 for RAR, sensitivities and specificities were 100% and 90%, and 100% and 84%, respectively. Using the published duplex criteria resulted in sensitivities and specificities of 100% and 74% for PSV, and 50% and 89% for RAR.
Conclusion:
Duplex US is a sensitive modality for detecting in-stent restenosis if laboratory-specific threshold values are used.
Related Concept Videos
Imaging Studies II: Ultrasonography
Imaging Studies VII: Vascular Imaging
Ultrasound II: Endoscopic Ultrasound and FibroScan
Endoscopic Ultrasound (EUS):
Assessing Blood pressure using a doppler ultrasound
Pre-Procedural Guidelines for Doppler Ultrasound Blood Pressure Assessment:
Preparation of Equipment: