Clinical, biochemical, and hygiene assessment of stabled horses provided continuous or intermittent access to

D A Freeman1, N F Cymbaluk, H C Schott

  • 1Department of Veterinary and Animal Science, College of Food and Natural Resources, University of Massachusetts, Amherst 01003, USA.

Abstract

Related Concept Videos

Diagnosing Acidosis and Alkalosis01:24

Diagnosing Acidosis and Alkalosis

Diagnosing acid-base imbalances involves systematically analyzing arterial blood samples, focusing on three key measurements: pH, bicarbonate (HCO3−) concentration, and carbon dioxide partial pressure (PCO2). This analysis follows a four-step process that helps identify the imbalance's underlying cause and nature.
First, the pH level is assessed to determine whether the blood pH is normal (7.35–7.45), low (acidosis), or high (alkalosis).
Next, the PCO2  and HCO3−  values are examined to...
Tonicity in Animals00:59

Tonicity in Animals

The tonicity of a solution determines if a cell gains or loses water in that solution. The tonicity depends on the permeability of the cell membrane for different solutes and the concentration of nonpenetrating solutes in the solution within and outside of the cell. If a semipermeable membrane hinders the passage of some solutes but allows water to follow its concentration gradient, water moves from the side with low osmolarity (i.e., less solute) to the side with higher osmolarity (i.e.,...
Tonicity in Animals01:16

Tonicity in Animals

Tonicity describes the amount of solute in a solution. The measure of the tonicity of a solution, or the total amount of solutes dissolved in a specific amount of solution, is called its osmolarity. Three terms—hypotonic, isotonic, and hypertonic—are used to relate the osmolarity of a cell to the osmolarity of the extracellular fluid that contains the cells. In a hypotonic solution, such as tap water, the extracellular fluid has a lower concentration of solutes than the fluid inside the cell,...
Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
Handwashing I: Introduction and Types of Equipment01:18

Handwashing I: Introduction and Types of Equipment

Handwashing is hand hygiene with plain or antimicrobial soap and water to physically remove dirt, organic material, and microorganisms. However, it may not kill all microorganisms. The handwashing procedure requires a hand wash basin, liquid soap, paper towels, a domestic waste bin, and disposable nail cleaner as optional equipment.
Hand wash basins in clinical areas should have faucets that can be turned on and off without using the hands; that is, they should be non-touch or lever-operated.
Continuous Renal Replacement Therapy01:30

Continuous Renal Replacement Therapy

Continuous Renal Replacement Therapy, also known as CRRT, is a procedural treatment for acute kidney injury (AKI) that gradually removes uremic toxins and fluids while maintaining acid-base balance and stabilizing electrolytes. It is particularly useful for hemodynamically unstable patients. Unlike intermittent hemodialysis, which is faster, CRRT provides a gentler approach over 24 hours, closely mimicking the function of natural kidneys. However, CRRT is not ideal for patients with...