XPS, EDX and FTIR analysis of pulsed laser deposited calcium phosphate bioceramic coatings: the effects of various...

Many techniques have been used to produce calcium phosphate, especially hydroxyapatite (HA), coatings on metallic implant surfaces for improved biocompatibility. Although some techniques have produced coatings used clinically, the long-term stability of the coating/implant is still questionable. As a new technique for making HA coatings, pulsed laser deposition (PLD) shows some advantages in controlling the coatings' crystal structure and composition. In this study, three types of HA target and two wavelengths of laser were used to produce calcium phosphate coatings. Despite PLDs ability to improve the crystal structure by incorporating water vapor into the deposition process, the characterization with EDX and XPS showed that coatings had different Ca/P ratios from that of the pure HA targets, which almost assured the presence of non-HA phases. FTIR spectra also showed differences in phosphate bands of coatings and targets although the difference in data collecting modes might have been a factor. The observed differences might be related to the differences between the surface and bulk chemistries of the coatings. Nevertheless, when evaluating the suitability of the PLD technique for making HA coatings, the possibility of the formation of non-HA phases cannot be excluded, although it may not necessarily be a negative factor.