Bond strengths to endodontically-treated teeth
Related Experiment Video
Updated: Oct 17, 2026
Standardized Protocol to Evaluate the Effect of Surface Treatments, Luting Cements, and Thermocycling on PEEK–Composite Bond Strength
Published on: June 9, 2026
T Nikaido1, Y Takano, Y Sasafuchi
1Department of Operative Dentistry, Faculty of Dentistry, Tokyo Medical and Dental University, Japan. t.nikaido.odnt@dent.tmd.ac.jp
Purpose:
To evaluate the bond strengths of three different types of resin bonding systems to teeth prepared for endodontic treatment.
Materials And Methods:
Access cavity preparation and removal of pulpal tissue were performed in bovine incisors. The root canals were chemically irrigated with saline (control), 5% sodium hypochlorite, 3% hydrogen peroxide, or combinations of both for 60 s. After storage in water for 1 d, the dentin surface was ground to a flat surface with 600-grit SiC under water. The area for bonding was demarcated with a vinyl tape (4 mm-in-diameter hole), and bonded using either Clearfil Liner Bond II, Single Bond, or Superbond C&B. After storage in 37 degrees C water for 1 d, tensile bond strengths were measured using a universal testing machine at a crosshead speed of 2 mm/min. Ten teeth were tested for each group.
Results:
One-way ANOVA and Fisher's PLSD test revealed that Single Bond and Superbond C&B had a statistically lower (P < 0.05) bond strengths in the chemical irrigation groups compared with the control group.
Related Concept Videos
01:12Bonding and Strength of Aggregate
02:40Chemical Bonds
Atoms participate in a chemical bond formation to acquire a completed valence-shell electron configuration similar to that of the noble gas nearest to it in atomic number. Ionic, covalent, and metallic bonds are some of the important types of chemical bonds. Bond energy and bond length determine the strength of a chemical bond.
Types of Chemical Bonds
An ionic bond is formed due to electrostatic attraction between cations and anions. Often, the ions are formed by the transfer of electrons from...
01:20Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in ASTM C...
02:35Noncovalent Attractions in Biomolecules
Four types of noncovalent interactions are hydrogen bonds, van der Waals forces, ionic bonds, and hydrophobic interactions.
Hydrogen bonding results from the electrostatic attraction of a hydrogen atom covalently bonded to a strong-electronegative atom like oxygen,...