Maximum forces sustained during various methods of exiting commercial tractors, trailers and trucks

Related Experiment Video

Updated: Oct 17, 2026

An Instrumented Pull Test to Characterize Postural Responses
12:18

An Instrumented Pull Test to Characterize Postural Responses

Published on: April 6, 2019

F A Fathallah1, J P Cotnam

  • 1Liberty Mutual Research Center for Safety and Health, Hopkinton, MA 01748, USA. fadi.fathallah@libertymutual.com

Applied Ergonomics
|March 10, 2000
PubMed

More Related Videos

Structural Design and Manufacturing of a Cruiser Class Solar Vehicle14:57

Structural Design and Manufacturing of a Cruiser Class Solar Vehicle

Published on: January 30, 2019

Evaluation of an Exclusive Spur Dike U-Turn Design with Radar-Collected Data and Simulation11:41

Evaluation of an Exclusive Spur Dike U-Turn Design with Radar-Collected Data and Simulation

Published on: February 1, 2020

Related Concept Videos

Three Force Member01:27

Three Force Member

A rigid body subjected to three forces acting at three points is known as a three-force member. These forces must have concurrent lines of action, except for parallel forces, where the lines of action are parallel.
For example, consider a dumpster connected to a pin support at point A and a pin attached to a hydraulic cylinder at point B.
Friction: Problem Solving01:17

Friction: Problem Solving

Friction is an essential force that influences the motion of objects in daily life. Depending on the situation, it can be either beneficial or problematic. Consider a bus with a mass of three megagrams and its center of mass at a specific point, moving along a banked road at a constant speed. The coefficient of static friction between the tires and the road is 0.5. Find the maximum angle of the banked road at which the bus would not slip or tip.
Initially, a visual representation of the...
Work Done by Many Forces01:03

Work Done by Many Forces

The total work done on an object acted upon by multiple forces can be computed using two methods that give the same result. In one method, the work done by each force is first calculated. Then, those values are summed algebraically to calculate the total work done by all the forces. In the second method, the net force is first calculated by a vector sum of all the forces. Then, the work done by this force is obtained.
Since forces perpendicular to the displacement do no work, they do not...
Stresses under Combined Loadings01:23

Stresses under Combined Loadings

When analyzing a bent tube with a circular cross-section subjected to multiple forces, it is crucial to determine the stress distribution in order to maintain structural integrity under varied load conditions.
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Dry Friction01:30

Dry Friction

Dry friction occurs between two solid surfaces in contact as they attempt to move relative to one another. In daily life, dry friction is encountered in various forms, such as when walking on the ground, sliding an object across a table, or rubbing hands together. Despite its ubiquity, the underlying mechanisms behind dry friction are not readily visible.
To illustrate this concept, imagine a wooden crate resting on a rough, non-uniform horizontal surface. When an external force is applied to...
Design Consideration01:22

Design Consideration

Designing a structure involves a series of considerations, primarily the material's ultimate strength, calculated through tests that measure changes under increased force until the material reaches its breaking point or limit. The ultimate load, where the material breaks, is divided by its original cross-sectional area, resulting in the ultimate normal stress or strength. The ultimate shearing stress is another significant factor taken into account.
The factor of safety is another key aspect...