Fit factors for quarter masks and facial size categories

Respirator fit testing is necessary before entering hazardous working environments to ensure that the respirator, when worn, satisfies a minimum fit and that the wearer knows when the respirator fits properly. In the many countries that do not have fit testing or total inward leakage regulations (including Korea), however, many workers wearing respirators may be potentially exposed to hazardous environments. It is necessary to suggest a useful tool to provide an alternative for fit testing in these countries. This study was conducted to evaluate fitting performance for quarter-mask respirators, and fit factors in facial size categories based on face lengths and lip lengths of the wearers. A total of 778 subjects (408 males, 370 females) were fit tested for three quarter masks: Sejin Co. SK-6 (Ulsan, Korea), Yongsung Co. YS-2010 S (Seoul, Korea), and 3 M Co. Series 7500 Medium (MN, USA) masks with a PortaCount 8020 (TSI Co., USA). A facial dimension survey of the subjects was conducted to develop facial size categories, on the basis of face length and lip length. Geometric mean fit factors (GMFFs) of Series 7500 Medium were found to be the highest of the three respirators. All of the respirators were more suitable for males than females in fitting performance. The Series 7500 Medium fitted a large number of the males tested, since the GMFFs for males were above 100 for every box of facial size categories, and high pass proportion rates were shown at an individual fit factor level of 100. The YS-2010 S provides an adequate fit for males in a limited range of facial dimensions. The Series 7500 Medium is more limited in providing adequate fit for females at specific facial dimensions than for males. For adequate fitting performance, the SK-6 is not preferentially recommended for Korean male and female workers due to low GMFFs and pass proportions. The result of this study indicates that after more accurate studies are performed, facial size categories, on the basis of facial dimensions, could be a useful tool to assist in the selection of adequately fitting respirators for workers in the countries having no fit testing requirements.