Related Experiment Video
Updated: May 5, 2026

High-resolution Thermal Micro-imaging Using Europium Chelate Luminescent Coatings
Published on: April 16, 2017
Detection of doubled shot noise in short normal-metal/superconductor junctions
Abstract:
Shot noise refers to the fluctuations in electrical current through a device arising from the discrete nature of the charge-carrying particles. Recent experiments have exploited the fact that the shot noise is proportional to the charge of the carriers to establish fractional quantization of quasiparticles in the fractional quantum Hall effect. By a similar argument, it is expected that when a superconducting reservoir emits Cooper pairs, (which have a charge twice that of an electron) into a short normal-metal wire, the shot noise should be double that obtained for a normal-metal reservoir. Although the charge of Cooper pairs has been well established by flux quantization and tunnel experiments, doubling of their shot noise has not yet been observed. Here we report a shot-noise experiment using a short diffusive normal-metal superconductor contact, in which we confirm the predicted noise behaviour for double charges. The measurements, taken over a large range of bias current, establish that phase coherence is not required to observe the effect.
More Related Videos
Related Concept Videos
¹H NMR: Interpreting Distorted and Overlapping Signals
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are...
Diamagnetic Shielding of Nuclei: Local Diamagnetic Current
¹³C NMR: ¹H–¹³C Decoupling
A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
Double Resonance Techniques: Overview
Spin decoupling is usually achieved by...
Metal-Semiconductor Junctions
Schottky Barriers
Schottky barriers arise when a metal with a work function (Φm) contacts a semiconductor with a different work function (Φs). Initially, electrons transfer until the Fermi levels of the metal and semiconductor align at equilibrium. For instance, if Φm > Φs, the semiconductor Fermi level is higher than the metal's before contact. The...
Biasing of Metal-Semiconductor Junctions
In Schottky junctions, where the semiconductor is n-type, applying a positive voltage to the metal relative to the semiconductor reduces its Fermi...

