Related Experiment Video
Updated: Sep 27, 2026

Aip1p Dynamics Are Altered by the R256H Mutation in Actin
Published on: July 30, 2014
Influence of ADP on cross-bridge-dependent activation of myofibrillar thin filaments
D Zhang1, K W Yancey, D R Swartz
1Department of Anatomy and Cell Biology, Indiana University Medical School, Indianapolis 46202, USA.
Abstract:
Contraction of skeletal muscle is regulated by calcium at the level of the thin filament via troponin and tropomyosin. Studies have indicated that strong cross-bridge binding is also involved in activation of the thin filament. To further test this, myofibrils were incubated with a wide range of fluorescent myosin subfragment 1(fS1) at pCa 9 or pCa 4 with or without ADP. Sarcomere fluorescence intensity and the fluorescence intensity ratio (non-overlap region/overlap region) were measured to determine the amount and location of bound fS1 in the myofibril. There was lower sarcomere fluorescence intensity with ADP compared to without ADP for both calcium levels. Similar data were obtained from biochemical measures of bound fS1, validating the fluorescence microscopy measurements. The intensity ratio, which is related to activation of the thin filament, increased with increasing [fS1] with or without ADP. At pCa 9, the fluorescence intensity ratio was constant until 80-160 nM fS1 without ADP conditions, then it went up dramatically and finally attained saturation. The dramatic shift of the ratio demonstrated the cooperative character of strong cross-bridge binding, and this was not observed at high calcium. A similar pattern was observed with ADP in that the ratio was right-shifted with respect to total [fS1]. Saturation was obtained with both the fluorescence intensity and ratio data. Plots of intensity ratio as a function of normalized sarcomere intensity (bound fS1) showed little difference between with and without ADP. This suggests that the amount of strongly bound fS1, not fS1 state (with or without ADP) is related to activation of the thin filament.
More Related Videos
08:02Using Microfluidics and Fluorescence Microscopy to Study the Assembly Dynamics of Single Actin Filaments and Bundles
Published on: May 5, 2022
06:48Tuning the Contractility and Deformation Modes of Active Actin-Based Assemblies In Vitro: From Two-Dimensional Active Networks to Liquid Crystal Drops
Published on: July 11, 2025
Related Concept Videos
Cross-bridge Cycle
Actin Polymerization
The nucleation phase involves forming a stable nucleus consisting of three actin monomers to form a new actin filament. Actin-binding proteins such as formins and Arp2/3 complex help filament growth post-nucleation. The Formins form straight actin...
Generation of Straight or Branched Actin Filaments
Arp2/3 Complex
Arp2/3 complex is a seven-subunit complex consisting of two proteins similar to actin- Arp2 and Arp3, and five other subunits that help keep Arp2 and Arp3 inactive. When required, the complex is...
Actin Filament Depolymerization
In F-actin, the ADF/cofilin proteins...
Actin and Myosin in Muscle Contraction
Actin Treadmilling