Information contained in the radiating ultrasound during ultrasonic welding

During ultrasonic welding, unnecessary ultrasound together with audible sound is radiated into the air. Audible sound is noisy and uncomfortable, and ultrasound may have bed effects on adjacent equipment. However, it is considered that these sounds potentially contain useful information such as welding state. This article reports the relationship between radiated ultrasound and the change of the welding state during ultrasonic welding. It is known that the welding state can be presumed from the change of the mechanical load impedance, which can be calculated from resonant frequency, motional voltage and the driving current of the vibrating system for the welder when a constant-velocity motional-feedback power oscillator is used. In this study, radiated ultrasound picked up with a microphone and an amplifier is recorded and analyzed with a personal computer. Analyzed results are compared with the change of the mechanical load impedance that is also calculated from the recorded data of the resonant frequency, motional voltage and the driving current of the vibrating system for the welding. Experiments were made on the ultrasonic welding of plastic rods. The relationship between the parameters of radiated ultrasound and the electrical parameters of the vibrating system were compared. The peak amplitude of the radiated ultrasound and the mechanical impedance versus time were very similar. It is shown in this study that radiated ultrasound contains lots of useful information.