Fractionation of halogenated organic matter present in rain and snow

Laniewski1, Boren, Grimvall

  • 1Department of Water and Environmental Studies, Linkoping University, Sweden.

Chemosphere
|July 20, 2000
PubMed

Related Concept Videos

Precipitation of Ions03:11

Precipitation of Ions

Predicting Precipitation
The equation that describes the equilibrium between solid calcium carbonate and its solvated ions is:
Formation of Halohydrin from Alkenes02:41

Formation of Halohydrin from Alkenes

An alkene, such as propene, reacts with bromine in the presence of water to yield a halohydrin. Halohydrins contain a halogen and a hydroxyl group attached to adjacent carbons. When the halogen is bromine, it is called a bromohydrin, while a chlorohydrin has chlorine as the halogen.
Radical Substitution: Halogenation of Alkanes and Alkyl Substituents01:27

Radical Substitution: Halogenation of Alkanes and Alkyl Substituents

In the presence of heat or light, alkanes react with molecular halogens to form alkyl halides by a substitution reaction called radical halogenation. This reaction has three steps: initiation, propagation, and termination, as seen in the radical chlorination of methane to produce methyl chloride.
In the initiation step of the reaction, the chlorine molecule undergoes homolytic cleavage in the presence of light or heat, forming two highly reactive chlorine radicals. Propagation occurs in two...
Mass Spectrometry: Alkyl Halide Fragmentation01:22

Mass Spectrometry: Alkyl Halide Fragmentation

Chlorine isotopes exist as 35Cl and 37Cl in a 3:1 ratio, while bromine isotopes exist as 79Br and 81Br in a 1:1 ratio. The mass spectrum of alkyl halides typically produces two distinct molecular ion peaks, the molecular ion peak, [M], and the molecular ion plus two, [M + 2] peak. The relative heights of these two peaks are proportional to the isotopic abundance ratios of the halide. For example, 2‐chloropropane and 1‐bromopropane display two peaks with relative peak heights in a 3:1 and 1:1...
Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
Precipitation and Co-precipitation01:17

Precipitation and Co-precipitation

Precipitation and coprecipitation methods can be used to separate a mixture of ions in a solution. In qualitative inorganic analysis, ions that form sparingly soluble precipitates with the same reagent are separated based on the differences in solubility products. For example, consider the separation of Cu(II) and Fe(II) ions by precipitation as insoluble sulfides. First, copper(II) sulfide is precipitated by the addition of acidic H2S, where the dissociation of H2S is suppressed. Adding H2S...