Related Experiment Video
Updated: Jul 28, 2026

Deep Vein Thrombosis Induced by Stasis in Mice Monitored by High Frequency Ultrasonography
Published on: April 13, 2018
Numerical model of deep venous thrombosis detection using venous occlusion strain gauge plethysmography
I C Turner1, M A McNally, B M O'Connell
1Experimental Cardiac Electrophysiology Unit, Papworth Hospital, Cambridge. ian.turner@papworth-tr.anglox.nhs.uk
Abstract:
Strain gauge plethysmography (SGP) is a non-invasive method used in the detection of deep venous thrombosis (DVT). The technique is based on the measurement of calf volume changes in response to venous occlusion by a thigh cuff, the volume changes reflecting the rates of arterial inflow and venous outflow. A numerical model of the blood circulation within the limb and the response of this to a SGP test has been derived, based on treating the different parts of the circulatory system in the leg as resistance and capacitance elements. The simulation results were compared with clinical studies and support the ability of SGP to detect non-occlusive clots of more than 50-60% of the lumen, as well detecting calf vein occlusion. The non-linear behaviour of the venous compliance with intra-luminal pressure appears to be a particularly important factor within the model. In addition, increases in venous tone due to post-operative venospasm were shown to be a potential source of false positive results.
Related Concept Videos
Measurements of Strain
Assessment of the Cardiovascular System III: Palpation
Jugular Venous Pressure (JVP) Measurement
Position the patient at a thirty- to forty-five-degree angle or in a semi-fowler's position. Look for the highest point of pulsation in the internal jugular vein and measure the vertical distance to the angle of Loius or sternal angle. A normal JVP is 3-4 cm above the...
Venous Thrombosis I: Introduction
Venous Thrombosis II: Clinical Manifestations and Diagnostic Studies
Venous Thrombosis III: Interprofessional Care

