Related Experiment Video
Updated: Aug 9, 2026

Substantiating Appropriate Motion Capture Techniques for the Assessment of Nordic Walking Gait and Posture in Older Adults
Published on: May 12, 2016
Load carriage energy expenditure with and without hiking poles during inclined walking
B H Jacobson1, T Wright, B Dugan
1Oklahoma State University, Stillwater, USA. BHJ52@OKSTATE.EDU
Abstract:
The purpose of this study was to compare load carriage energy expenditure with and without using hiking poles. Twenty male volunteers aged 20-48yr (Mean=29.8yr) completed two randomly ordered submaximal treadmill trials with poles (E) and without poles (C). Poles and load (15 kg backpack) were fitted for each subject according to the manufacturers' suggestions. Heart rates (HR), minute ventilation (V(E)), oxygen consumption (O2), caloric expenditure (Kcal), and rating of perceived exertion (RPE) were recorded at the end of each minute. Two trials separated by one week consisted of a constant treadmill speed of 1.5 mph and 1 min at 10% grade, 2 min at 15% grade, 2 min at 20% grade, and 10 min. at 25% grade. Mean HR (E = 144.8 +/- 24.4 b x min(-1); C = 144.0 +/- 25.7 b x min(-1)) and mean V(E) (E=51.4 +/- 15.8L x min(-1); C=50.8 +/- 17.0L x min(-1)), VO2 (E = 26.9 +/- 6.1 ml x kg(-1) x min(-1); C = 27.4 +/- 6.6 ml x kg(-1) x min(-1)), and Kcal (E = 10.6 +/- 2.9 Kcal x min(-1); C = 10.8 +/- 3.1 Kcal x min(-1)) were not significantly different between the two conditions. RPE (E = 13.28 +/- 1.2; C = 14.56 +/- 1.2) was significantly lower (P < 0.05) with hiking poles. Analysis of paired time points yielded no significant differences in HR, VO2, V(E), and Kcal, however, RPE means were significantly lower for 5 of the last 7 trial minutes with the use of poles. These results suggest that during load carriage on moderate grade, the weight and use of hiking poles does not increase energy expenditure but may provide reduced perceptions of physical exertion.
Related Concept Videos
Load along a Single Axis
Consider a beam of length L subjected to a varying load, which is a combination of parabolic and trapezoidal load distribution along the x-axis. In this case, it is essential to determine the resultant loads, their locations, and...
Work Done Over an Inclined Plane
The work done by gravity to move a rigid body, or the work done by an opposing force to move a rigid body against gravity, can be calculated using the center-of-mass framework. It is the line integral of the force of gravity over the path, considered positive if...

