Agar-screew specimen carrier for bulk processing of biopsy material for electron microscopy

A specimen carrier for processing large numbers of biopsy materials for epoxy embedding and electron microscopy is described. Commercially available 18-mesh stainless steel or 16-mesh aluminum wire screening is used. The screening is cut into 1 x 3-inch strips. One corner is snipped off for orientation purposes. Four drops of warm 4% agar is placed on a prewarmed standard microscopic glass slide. A thin agar support film is formed on the bottom side of the horizontally held wire screen by lightly running it against the agar. Tissue blocks trimmed to 1 mm-3 are blotted on filter paper and placed in a prearranged order on the top surface of the support film. A thin top coating of agar is applied on the specimen by touching it with the tip of a pasteur pipette containing warm 4% agar. The agar-screen unit with the mounted specimens is stabilized in 4% buffered formalin and rinsed with Sorenson's phosphate buffer, pH 7.4, with 6.8% sucrose. It is then processed as a unit through routine osmium tetroxide postfixation, alcohol dehydration, and Epon 812 filtration. The tissue blocks are plucked off the agar support film with fine-tipped tweezers and embedded in individual capsules. No difficulty in thin sectioning was encountered and examination of the sections under the electron microscope showed good infiltration by the epoxy resin.