Strain patterns in cervical enamel of teeth subjected to occlusal loading

This study was planned to investigate the variations in strains in enamel under different patterns of occlusal loading, using three-dimensional finite element analysis (3D FEA) and strain gage measurements in extracted teeth.

A 3D FEA model of a mandibular second premolar was used to investigate effects of occlusal load on enamel surface strains, particularly in response to oblique directions of cuspal loading. Point loads of 100 N were applied axially and at 45 degrees from the vertical on the buccal or lingual incline of the buccal cusp, either in the bucco-lingual plane or at varying mesio-distal angulations (up to +/- 20 degrees). Patterns of strain observed in the FEA model were confirmed experimentally using strain gages on extracted premolars mounted in a servohydraulic testing machine.

Strains predicted from the FEA model were in excellent agreement with the strain gage measurements. Strains were concentrated near the cementoenamel junction (CEJ) regardless of load direction. A vertical load on the buccal cusp tip resulted in compressive strains on the buccal surface but small tensile strains in lingual cervical enamel. Strains resulting from oblique loads on buccal cusp inclines were complex and asymmetric, with either tension or compression occurring in any location depending on the site and angle of loading.

The magnitude, direction and character of strains in cervical enamel are highly dependent on patterns of loading. The asymmetric pattern of strains in buccal cervical enamel in response to oblique occlusal forces is consistent with the common clinical picture of asymmetric non-carious cervical lesions.