Development of spray-dried acetaminophen microparticles using experimental designs

Experimental factorial designs were built to investigate the effects of five parameters on production yields and moisture contents of spray-dried products. These factors concerned both the solution feed (drug concentration, colloidal silica concentration and polymer/drug ratio) and the spray dryer (inlet temperature and feed rate). Three formulations containing cellulose derivatives and acetaminophen were tested. The aim of the study was to optimize the operating conditions to maximize production yields while minimizing moisture contents. First screening experiments consisting of fractional factorial designs revealed the most significant factors to be inlet temperature, feed rate and their interaction for both formulations containing sodium carboxymethylcellulose and feed rate and colloidal silica concentration for the formulation containing microcrystalline cellulose. Then, the optimal operating conditions were estimated by response surface methodology. Central rotational composite designs showed quadratic models were adequate. New assays were carried out using these last conditions to evaluate both the repeatability and reproducibility of the spray-drying technique. Yields above 80% and moisture content of approximately 1% were reached. The characterization of microparticles revealed the poor flowability of the spray-dried products due to significant cohesiveness and very small size (less than 55 microm).