Diametral tensile strength and compressive strength of a calcium phosphate cement: effect of applied pressure

The diametral tensile strength (DTS) and compressive strength (CS) of a calcium phosphate cement comprised of tetracalcium phosphate and dicalcium phosphate anhydrous were studied. Cement powder and water were mixed at a powder/liquid ratio of 4.0. The resulting cement pastes were placed in molds and a pressure ranging from 0-2.8 MPa was applied for various lengths of time (0.5-24 h). DTS and CS measurements were conducted on 24-h wet samples. The strength was found to be significantly (p<0.05) affected by the pressure but not by the time. Samples prepared under a pressure of 0.7 MPa had a mean DTS value of 10.8+/-1.0 MPa (n = 5), which is comparable to the values reported in the literature for the same cement prepared under similar conditions. In contrast, the mean CS value obtained in the present study, 66.1+/-5.0 MPa (n = 5), was significantly higher than the value (51+/-4.5 MPa) previously reported. The higher CS may be attributed to an improved mold design that may reduce sample damage during demolding, and to the use of a loading device that applied a constant pressure to the sample during setting. The average standard deviation of the mean for the 19 DTS sample groups (n = 5 in each group) was 1.1 MPa, corresponding to 9.6% of the mean DTS value. The average standard deviation of the 7 CS sample groups (n = 5 in each group) was 4.5 MPa, corresponding to 7.1% of the mean CS value. Published 2000 John Wiley & Sons, Inc.