Investigation into the tribological condition of acetabular tissue after bipolar joint replacement hip surgery

The aim of this research was to investigate the tribological condition of acetabular tissue before and after bipolar hip surgery. Articular cartilage was taken from the femoral head of patients undergoing primary joint replacement as a control. Tissue was also taken from the acetabular cups of patients undergoing revision hip surgery after primary bipolar surgery and compared with the control cartilage. The biomechanical characteristics of the two tissue types were tested using friction and compression tests. The friction tests were carried out on a sliding friction rig under nominal contact stresses of 0.5 and 4 MPa. The compression tests were carried out under a 0.8 MPa contact stress. The majority of the bipolar patients produced friction coefficients that were significantly higher than those produced by the control group, and the compression tests highlighted that the tissue from the bipolar patients produced a much greater rate of increase in displacement compared with the control cartilage. Histology showed major differences between the control cartilage and the bipolar tissue. The control cartilage showed a healthy collagen structure with a good distribution of proteoglycan whereas the majority of the bipolar tissue had lost tissue architecture and had a sparse fibrous structure. The high friction coefficients with the bipolar tissue imply that the frictional torque at the outer head of the bipolar prosthesis would be large compared with the inner bearing frictional torque. It was therefore predicted that the motion of the bipolar prosthesis should occur at the inner bearing.