Related Experiment Video
Updated: Jul 25, 2026
Sealable Femtoliter Chamber Arrays for Cell-free Biology
Published on: March 11, 2015
Influence of additive noise on transitions in nonlinear systems
Abstract:
The effect of additive noise on transitions in nonlinear systems far from equilibrium is studied. It is shown that additive noise in itself can induce a hidden phase transition, which is similar to the transition induced by multiplicative noise in a nonlinear oscillator [P. Landa and A. Zaikin, Phys. Rev. E 54, 3535 (1996)]. Investigation of different nonlinear models that demonstrate phase transitions induced by multiplicative noise shows that the influence of additive noise upon such phase transitions can be crucial: additive noise can either blur such a transition or stabilize noise-induced oscillations.
Related Concept Videos
01:26Classification of Systems-I
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
01:23Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be calculated...
01:24Effects of feedback
Feedback significantly modifies the gain of a control system. The gain of a system without feedback is altered by a factor of one plus GH, where G represents...
01:26Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
01:26Linear Approximation in Frequency Domain
In contrast, nonlinear systems do not inherently possess these properties. However, for small deviations around an operating point, a nonlinear system can often be approximated as linear.
01:13Parameters Affecting Nonlinear Elimination: Zero-Order Input, First-Order Absorption and Two-Compartment Model
When a drug is administered through a constant intravenous infusion and eliminated via nonlinear pharmacokinetics, it follows zero-order input. For example, oral drugs undergo first-order absorption upon administration and are eliminated through nonlinear pharmacokinetics.
In the case of subcutaneously administered drugs,...