The marginal-ridge rest seat

R D Mazurat1

  • 1Department of Restorative Dentistry, University of Manitoba, Winnipeg. rmazurat@ms.umanitoba.ca

Related Concept Videos

Rab Cascades01:25

Rab Cascades

Rab GTPases act in a regulated cascade during membrane fusion, helping the lipid bilayers mix. The Rab family of proteins are active when bound to GTP, and inactive when bound to GDP. Hence, they act as guanine nucleotide-dependent molecular switches. Rab-GTP recognizes and binds to long or short-range tethering proteins to capture the target vesicle. These tethers coordinate with SNAREs on the vesicle and the target membrane to assemble the trans SNARE complex that locks the mixing bilayers.
Margin of Error01:27

Margin of Error

The margin of error is also called the maximum error of an estimate. The margin of error is the maximum possible or expected difference between the observed sample parameter value and the actual population parameter value. For proportion, it is the maximum difference between the value of sample proportion obtained from the data and the true value of population proportion. As the true value of the population parameter is not known, the margin of error is calculated using the sample statistic.
Vertebral Column: Regions and Curvature01:16

Vertebral Column: Regions and Curvature

The vertebral column or spine is a flexible column that supports the head, neck, and body and  allows for their movements. It also protects the spinal cord.
Regions of the Vertebral Column
In an adult, the spine is subdivided into five regions: the cervical, the thoracic, the lumbar, the sacral, and the coccygeal region. The spine initially develops as a series of 33 vertebrae; after 20 years of age, the nine bones in the sacral region, five sacral, and four coccygeal bones fuse to form the...
Rolling Resistance01:21

Rolling Resistance

When a solid cylinder rolls steadily on a rigid surface, the normal force applied by the surface on the cylinder is perpendicular to the tangent at the contact point. However, since no materials are entirely rigid, the surface's reaction to the cylinder involves a range of normal pressures.
For instance, imagine a hard cylinder rolling on a comparatively soft surface. The cylinder's weight compresses the surface beneath it. As the cylinder moves, the material in front of it slows down due to...
Elevation of Intermediate Points on Vertical Curves01:20

Elevation of Intermediate Points on Vertical Curves

Vertical curves are essential in roadway design because they provide smooth transitions between varying roadway grades. Designing vertical curves involves calculating intermediate elevations and identifying the curve's highest or lowest point, which is essential for optimal roadway performance.Intermediate elevations on a vertical curve are determined using the tangent offset method. This method considers the initial elevation at the start of the curve, the grades, and the curve's geometry. The...
Midpoint Rule01:20

Midpoint Rule

Approximating areas under curved boundaries is a common problem in applied mathematics, particularly when an exact calculation is difficult or impractical. One effective numerical method for this purpose is the Midpoint Rule, which provides an estimate of the area under a curve by using rectangular approximations over a specified interval.Description of the Midpoint RuleThe Midpoint Rule begins by dividing the given interval into a number of equal subintervals. For each subinterval, the...