Related Experiment Video
Updated: Oct 10, 2026

Monitoring Equilibrium Changes in RNA Structure by 'Peroxidative' and 'Oxidative' Hydroxyl Radical Footprinting
Published on: October 17, 2011
Quantitation of hydroxyl radical during fenton oxidation following a single addition of iron and peroxide
1Department of Chemistry, University of New Orleans, LA 70148, USA.
Abstract:
Chemical probes were used to study the formation of hydroxyl radical in aqueous iron-hydrogen peroxide reaction. Hydroxyl radical formation rate and time dependent concentration were determined in pure water, in aqueous fulvic acid (FA) and humic acid (HA) solutions, and in natural surface waters. Indirect determinations of hydroxyl radical were made by quantitating hydroxyl radical reactions with probe compounds under controlled conditions. High probe concentrations were used to determine radical formation rates and low probe concentrations were used to determine time dependent radical concentration. Two independent probes were used for intercomparison: benzoic acid and 1-propanol. Good agreement between the two probes was observed. Natural water matrices resulted in lower radical formation rates and lower hydroxyl radical concentrations, with observed formation rate and yield in natural waters up to four times lower than in pure water. HA and FA also reduced hydroxyl radical formation under most conditions, although increased radical formation was observed with FA at certain pH values. Hydroxyl radical formation increased linearly with hydrogen peroxide concentration.
Related Concept Videos
Oxidation of Phenols to Quinones
o-hydroxy phenols are oxidized to o-quinones and p-hydroxy phenols to p-quinones. Such redox reactions involve the transfer of two electrons and two protons. The reversible redox property is crucial in...
Oxidation of Alkenes: Syn Dihydroxylation with Potassium Permanganate
Radical Autoxidation
Strong Acid and Base Solutions
Titration Calculations: Strong Acid - Strong Base
A titration is carried out for 25.00 mL of 0.100 M HCl (strong acid) with 0.100 M of a strong base NaOH. The pH at different volumes of added base solution can be calculated as follows:
(a) Titrant volume = 0 mL. The solution pH is due to the acid ionization of HCl. Because this is a strong acid, the ionization is complete and the hydronium ion molarity is 0.100 M. The pH of the solution is then:
Oxidation of Alkenes: Anti Dihydroxylation with Peroxy Acids
