Related Experiment Videos
Structural characterization of beta-D-(1 --> 3, 1 --> 6)-linked glucans using NMR spectroscopy
Abstract:
Nondestructive structural analysis of a series of beta-D-(1 --> 3, 1 --> 6)-linked glucans (laminaran, curdlan, yeast glucan, scleroglucan, etc.) was performed using two-dimensional NMR spectroscopy. The relative ratios of H-1 at different AGUs provided the information about DPn and DB. The alpha-, and beta-anomeric protons on reducing terminals were assigned at 5.02 to approximately 5.03 ppm (J 3.6 to approximately 3.7 Hz), and 4.42 to approximately 4.43 ppm (J 7.6 to approximately 7.9 Hz), respectively, whereas the H-1 protons of internal AGUs and beta-(1 --> 6)-branched AGUs appeared at 4.56 to approximately 4.59 ppm (J 7.6 to approximately 7.8 Hz), and 4.26 to approximately 4.28 ppm (J 7.6 to approximately 10.6 Hz), respectively, in a mixed solvent of 6:1 Me2SO-d6-D2O at 80 degrees C. In the solvent, the OH peaks were eliminated from the spectra allowing the H-1 protons to appear clearly. In addition, the nonreducing terminal H-1 and H-1 at the AGU next to reducing terminal could be assigned at 4.45 to approximately 4.46 ppm (J 7.8 to approximately 7.9 Hz), and 4.51 to approximately 4.53 ppm (J 7.8 Hz), respectively. The DPn of the laminaran was 33 (polydispersity 1.12) and the DB was 0.07. The number of glucosyl units in the side chain of laminaran is more than one. The DPn and DB of the water-insoluble yeast glucan were 228 and 0.003, respectively. However the DPn of water soluble yeast glucan phosphate and curdlan was changed upon the number of freeze-drying processes and the content of water in the mixed solvent, respectively. And the DB of those were calculated as 0.02 and 0, respectively. The DB of scleroglucan was precisely calculated as 0.33, compared with the previously reported data. The H-1s at different AGUs of the various beta-D-(1 --> 3, 1 --> 6)-linked glucans having different DB can be exactly assigned by their chemical shifts in the mixed solvent system. This NMR analysis can be effectively used to determine the DP and DB of polysaccharides in a simple and non-destructive manner.