Voltammetric determination of isoxsuprine and fenoterol in dosage forms and biological fluids through nitrosation

A simple and highly sensitive voltammetric method was developed for the determination of isoxsuprine HCl (I) and fenoterol HBr (II) in dosage forms and biological fluids. The method is based on treatment of the two compounds with nitrous acid followed by measuring the cathodic current produced by the resulting nitroso derivatives. The voltammetric behavior was studied adopting Direct Current (DCt), Differential Pulse (DPP) and Alternating Current (ACt) polarography. Both compounds produced well-defined, diffusion-controlled cathodic waves over the whole pH range in Britton-Robinson buffers (BRb). At pH 11 and pH 9, the values of diffusion-current constants (Id), were 9.4 +/- 0.3 and 7.7 +/- 0.4 for I and II, respectively. The current-concentration plots for I were rectilinear over the range of 0.6-12 microg/ml and 0.1-12 microg/ml in the DCt and DPP modes, respectively. As for II, the range was 1-20 microg/ml and 0.1-20 microg/ml in the DCt and DPP modes, respectively. The minimum detectability (S/N = 2) were 0.02 microg/ml (approximately 6 x 10(-8) M) and 0.01 microg/ml (approximately 2.6 x 10(-8) M) for I and II, respectively, adopting the DPP mode. The proposed method was applied to the determination of both compounds in dosage forms and the results obtained were in good agreement with those obtained using reference methods. The proposed method was further applied to the determination of isoxsuprine in spiked human urine and plasma. The percentage recoveries adopting the DPP mode were 98.84 +/- 1.18 and 99.26 +/- 0.97, respectively.