An auto-continuous positive airway pressure device controlled exclusively by the forced oscillation technique
Related Experiment Video
Updated: Oct 9, 2026

Employing the Forced Oscillation Technique for the Assessment of Respiratory Mechanics in Adults
Published on: February 9, 2022
J H Ficker1, F S Fuchs, G H Wiest
1Medical Dept 1, University of Erlangen-Nuremberg, Germany.
Abstract:
The forced oscillation technique (FOT) has been demonstrated to be a very sensitive tool for the assessment of upper airway obstruction during nasal continuous positive airway pressure (CPAP) therapy for obstructive sleep apnoea (OSA). The present study was designed to evaluate the therapeutic efficacy of a novel auto-CPAP device based exclusively on the FOT. Following manual CPAP titration, 18 patients with OSA (mean apnoea/hypopnoea index (AHI) 48.0+/-28.1) were allocated to conventional CPAP and auto-CPAP treatment under polysomnographic control in randomized order. The patients were asked to assess their subjective daytime sleepiness using the Epworth Sleepiness Scale (ESS). The mean AHI during auto-CPAP treatment was 3.4+/-3.4 and was comparable with that obtained during conventional CPAP treatment (4.2+/-3.6). The analysis of sleep architecture, the arousal index (6.6+/-2.1 versus 7.3+/-4.4) or the ESS (5.6+/-1.8 versus 7.3+/-4.4) did not reveal any significant differences. However, the mean CPAP pressure during auto-CPAP treatment (0.84+/-0.26 kPa) and in particular the pressure applied in the lateral body position (0.74+/-0.35 kPa), was significantly lower than that employed in conventional CPAP treatment (0.93+/-0.16 kPa, both comparisons: p<0.05). The auto-continuous positive airway pressure device proved equally as effective as conventional continuous positive airway pressure. However, the mean treatment pressure was significantly reduced, especially when patients were sleeping in the lateral position.
Related Concept Videos
Mechanical Ventilation III: Noninvasive Ventilation
Noninvasive Positive-Pressure Ventilation (NIPPV)
Ventilatory Modes
There are three ventilatory modes: full support, partial support, and spontaneous. These are described below.
Full Support Modes
Full support modes include controlled mechanical ventilation, continuous mandatory...
Mechanical Ventilation II: Invasive Ventilation
Negative-Pressure Ventilators
Negative-pressure ventilators create a vacuum around the chest or body to draw air into the lungs, simulating breathing. This method does not require an...
Mechanical Ventilation I: Indication and Settings
Cardiopulmonary Resuscitation II: ACLS Airway Management
Oxygen Delivering System II: Venturi Mask and Transtracheal Oxygen
Venturi Mask
The Venturi mask, named after the Venturi effect, is designed to deliver precise oxygen concentrations. It consists of a large tube with an oxygen inlet that narrows down, causing a pressure drop that pulls air in through adjustable side ports. The mask is a lightweight,...

