Related Experiment Video
Updated: Oct 9, 2026

A Low Cost Setup for Behavioral Audiometry in Rodents
Published on: October 16, 2012
Effects of changes in stimulus level on phases of distortion product otoacoustic emissions
1Department of Ororhinolaryngology, School of Medicine, Tokai University, Tokai, Japan. t-harada@is.icc.u-tokai.ac.jp
Abstract:
Effect of changes in stimulus levels of both lower (f(1)) and higher (f(2)) stimulus tones on phases of 2f(1)-f(2) component of the distortion product otoacoustic emission (DPOAE) was examined in five normal hearing adults. The f(2) was fixed at 4004 Hz in all of the measurements, and the stimulus frequency ratio (f(2)/f(1)) was varied from 1.15 to 1.3. Change of the level of lower stimulus tone (L(1)) and the level of higher stimulus tone (L(2)) showed different effects on the DPOAE phases. The phase lags increased with increasing L(1), when f(2)/f(1) was above 1.22, whereas the phase gains increased with increasing L(1), when f(2)/f(1) was below 1.22. On the other hand, the difference in L(2) minimally affected DPOAE phase at most f(1)s. The previous studies about basilar membrane vibration revealed that phase lags increase with increasing stimulus level, when the stimulus frequency is below the best frequency, while phase gains increase with increasing stimulus level, when the stimulus frequency is above the best frequency, and the effect of phase change in stimulus level diminished, when the stimulus frequency was far above the best frequency. Based on the comparison between the results of the present study and the previous findings of others concerning basilar membrane vibration, the DPOAE generation site is assumed to be located at apical of the peak of the f(2) traveling wave.
More Related Videos
11:39Assessment of Audio-Tactile Sensory Substitution Training in Participants with Profound Deafness Using the Event-Related Potential Technique
Published on: September 7, 2022
14:05Behavioral Assessment of Hearing in 2 to 4 Year-old Children: A Two-interval, Observer-based Procedure Using Conditioned Play-based Responses
Published on: January 23, 2017
Related Concept Videos
Doppler Effect - II
Sound Intensity Level
The human ear can perceive an extensive range of sound intensity, necessitating the use of the logarithmic scale to define a physical quantity—the intensity level. It is a ratio of two intensities and hence a...
Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
Gain
Gain:
Suppose Vin is the input and Vout is the output signal to a circuit.