Mass and weight are often used interchangeably in everyday conversation. For example,  medical records often show our weight in kilograms, but never in the correct units of newtons. In physics, however, there is an important distinction. Weight is the pull of the Earth on an object. It depends on the distance from the center of the Earth. Weight dramatically varies if we leave the Earth's surface, unlike mass, which does not vary with location. On the Moon, for example, the acceleration due to...

In 1905, Albert Einstein published his special theory of relativity. According to this theory, no matter in the universe can attain a speed greater than the speed of light in a vacuum, which thus serves as the speed limit of the universe.
This has been verified in many experiments. However, space and time are no longer absolute. Two observers moving relative to one another do not agree on the length of objects or the passage of time. The mechanics of objects based on Newton's laws of motion,...

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...

Mass and weight are often used interchangeably in everyday conversation. For example,  medical records often show our weight in kilograms, but never in the correct units of newtons. In physics, however, there is an important distinction. Weight is the pull of the Earth on an object. It depends on the distance from the center of the Earth. Weight dramatically varies if we leave the Earth's surface, unlike mass, which does not vary with location. On the Moon, for example, the acceleration due to...

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added together...