Distribution functions of spring discharges according to their lithologies and the influence of lower limit to flow:...

Specific functions of distribution of the number of springs and of their contributions according to flow for each of nine lithological groups are established. These functions confirm the suitability of a general type of distribution (Sanz 1996), which is a borderline case of the lognormal distribution. The statistical methods proposed for the lithological types presented can be applied to any region if data on flow and lithology of the aquifers drained by springs are available. These methods have been applied to Spain, a representative region with varied geology, climate and topography; 71.2% of spring flow is supplied by limestones, 19.17% by alluvial sediments and marls, 6.7% by conglomerates and sandstones, and 3% by slates, plutonic rocks, quartzites, and other groups. Springs with discharge rates exceeding 2000 L/s exist only in limestones. The majority of springs with low flow occur in marls. If we consider springs with flow greater than 0.5 L/s, alluvial sediments, sandstones, marls, and limestones have the greatest density of springs per surface area, although the average flow varies greatly from one lithology to the next. The cumulative estimated discharge and the estimated number of springs depend upon the definition of the lower limit of flow. For example, total discharge is reduced by 30% if we eliminate all springs with flow lower than 0.5 L/min.