Comparison of methods for determination of microbial biomass in wastewater

Microbial biomass in wastewater was determined by methods used in environmental microbiology and by a method used in wastewater engineering based on a conceptual model simulating fundamental microbial processes in wastewater from measured oxygen uptake rates. The methods originating from environmental microbiology are based on staining and counting of cells for the determination of total cell biomass (acridine orange and DAPI), physiological state of cells (LIVE/DEAD BacLight) and activity of cells (reduction of the redox dye CTC and microautoradiography). Depending on the staining method applied, cell biomasses yielded 15-86% of the biomass defined by the model, and good correlations between cell biomass and model biomass were found. Cell biomass, oxygen uptake and acetate uptake were measured in wastewater, where acetate was added. Substrate uptake rates were found not to be proportional to the increases in cell biomass, suggesting that only a small fraction of the cell biomass was responsible for the main part of the substrate uptake. Despite the differences found between cell biomass and model biomass, it was recommended to use the conceptual model as an engineering tool for simulation of microbial processes and wastewater quality changes. However, there should be a clear distinction between the terms 'model biomass', 'cell biomass' and different activity measurements of cells.