Total synthesis of epothilone B, epothilone D, and cis- and trans-9,10-dehydroepothilone D

J D White1, R G Carter, K F Sundermann

  • 1Department of Chemistry, Oregon State University, Corvallis, OR 97331-4003, USA.

Related Concept Videos

Structure and Nomenclature of Ethers02:28

Structure and Nomenclature of Ethers

Structure and Bonding
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent groups, ethers can be classified into two...
Disubstituted Cyclohexanes: cis-trans Isomerism02:37

Disubstituted Cyclohexanes: cis-trans Isomerism

Depending upon the different spatial orientation of the substituents, the disubstituted cycloalkanes exhibit two types of stereoisomers. The cis isomers have the substituents on the same side of the ring, whereas the trans isomers have the substituents on the opposite sides. These stereoisomers exhibit different physical properties and cannot be interconverted without breaking the carbon-carbon bonds.
In cyclohexane, the substituents can occupy different positions generating distinct isomers.
Physical Properties of Ethers02:17

Physical Properties of Ethers

Overview
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Structure and Nomenclature of Epoxides02:38

Structure and Nomenclature of Epoxides

Cyclic ethers are heterocyclic compounds with an oxygen atom in the ring along with carbon atoms. They are named depending on the number of carbon atoms present in their ring system. Cyclic ethers with a three-membered ring system are called “oxirane”, four-membered ring systems as “oxetane”, five-membered ring systems as “oxolane”, and six-membered ring systems as “oxane”. The cyclic structure of these rings imposes angle strain, and this strain is more in the ring having a smaller number of...
Preparation of Epoxides03:00

Preparation of Epoxides

Overview
Epoxides result from alkene oxidation, which can be achieved by a) air, b) peroxy acids, c) hypochlorous acids, and d) halohydrin cyclization.
Epoxidation with Peroxy Acids
Epoxidation of alkenes via oxidation with peroxy acids involves the conversion of a carbon–carbon double bond to an epoxide using the oxidizing agent meta-chloroperoxybenzoic acid, commonly known as MCPBA. Since the O–O bond of peroxy acids is very weak, the addition of electrophilic oxygen of peroxy acids to...
Structure of Conjugated Dienes01:16

Structure of Conjugated Dienes

Introduction
Conjugated dienes are compounds characterized by the presence of alternating double and single bonds. In a conjugated system like 1,3-butadiene, the unhybridized 2p orbital on each carbon overlaps continuously, allowing the π electrons to be delocalized across the entire molecule. In contrast, this type of overlap does not occur in cumulated and isolated dienes, such as 2,3-pentadiene and 1,4-pentadiene, respectively. Instead, the π electrons remain localized between the double...