Related Experiment Video

Updated: Aug 6, 2026

A Novel Application of Musculoskeletal Ultrasound Imaging
10:53

A Novel Application of Musculoskeletal Ultrasound Imaging

Published on: September 17, 2013

A study of weight transmission through the knee joint with applied varus and valgus loads

J P Kostuik, O Schmidt, W R Harris

    Clinical Orthopaedics and Related Research
    |May 1, 1975
    PubMed

    More Related Videos

    Subject-specific Musculoskeletal Model for Studying Bone Strain During Dynamic Motion09:32

    Subject-specific Musculoskeletal Model for Studying Bone Strain During Dynamic Motion

    Published on: April 11, 2018

    In Vitro Application of a Wireless Sensor in Flexion-Extension Gap Balance of Unicompartmental Knee Arthroplasty07:33

    In Vitro Application of a Wireless Sensor in Flexion-Extension Gap Balance of Unicompartmental Knee Arthroplasty

    Published on: May 5, 2023

    Related Concept Videos

    Normal Strain under Axial Loading01:20

    Normal Strain under Axial Loading

    Normal strain under axial loading is an important concept in the field of mechanics of materials. Axial loading implies the application of a force along the axis of a material, like a column or bar. This force can either compress or stretch the material. In the context of axial loading, normal strain is the deformation experienced by the material in the direction of the loading force. It's calculated as the change in length divided by the original length of the material. This unitless ratio...
    Deformation of Member under Multiple Loadings01:11

    Deformation of Member under Multiple Loadings

    When a rod is made of different materials or has various cross-sections, it must be divided into parts that meet the necessary conditions for determining the deformation. These parts are each characterized by their internal force, cross-sectional area, length, and modulus of elasticity. These parameters are then used to compute the deformation of the entire rod.
    In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
    General Case of Eccentric Axial Loading01:12

    General Case of Eccentric Axial Loading

    Unsymmetrical bending occurs when the bending moment applied to a structural member does not align with its principal axis. This misalignment leads to complex stress distributions and deflection patterns that differ from symmetrical bending, which are essential for designing structures to withstand different loading conditions.
    Consider a member subjected to equal and opposite forces that are applied along a line that does not coincide with the member's neutral axis. In unsymmetrical bending,...
    Design of Transmission Shafts - Stress Analysis01:15

    Design of Transmission Shafts - Stress Analysis

    Designing a transmission shaft requires a thorough understanding of the stresses induced by bending moments and torques, especially in systems where power is transferred through gears. These forces create force-couple systems at the centers of the shaft's cross-sections, leading to both transverse and torsional loading. Although shearing stresses from transverse loads are typically smaller than those from torques and are often overlooked, the significant normal stresses from these loads...
    Stresses under Combined Loadings01:23

    Stresses under Combined Loadings

    When analyzing a bent tube with a circular cross-section subjected to multiple forces, it is crucial to determine the stress distribution in order to maintain structural integrity under varied load conditions.
    The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...