Checking out the G(2)/M transition

V A Smits1, R H Medema

  • 1The Netherlands Cancer Institute, Division of Molecular Biology H8, Plesmanlaan 121, 1066 CX Amsterdam, The Netherlands.

Related Concept Videos

Properties of Transition Metals02:58

Properties of Transition Metals

Transition metals are defined as those elements that have partially filled d orbitals. As shown in Figure 1, the d-block elements in groups 3–12 are transition elements. The f-block elements, also called inner transition metals (the lanthanides and actinides), also meet this criterion because the d orbital is partially occupied before the f orbitals.
M-Cdk Drives Transition Into Mitosis02:15

M-Cdk Drives Transition Into Mitosis

Checkpoints throughout the cell cycle serve as safeguards and gatekeepers, allowing the cell cycle to progress in favorable conditions and slow or halt it in problematic ones. This regulation is known as the cell cycle control system.
Cyclin-dependent kinases, or Cdks, work in concert with cyclins to control cell cycle transitions. M-Cdk, a complex of Cdk1 bound to M cyclin, is a well-known example of this coordinated control that drives the transition from the G2 to the M phase.
M cyclin...
M-Cdk Drives Transition Into Mitosis02:15

M-Cdk Drives Transition Into Mitosis

Checkpoints throughout the cell cycle serve as safeguards and gatekeepers, allowing the cell cycle to progress in favorable conditions and slow or halt it in problematic ones. This regulation is known as the cell cycle control system.
Cyclin-dependent kinases, or Cdks, work in concert with cyclins to control cell cycle transitions. M-Cdk, a complex of Cdk1 bound to M cyclin, is a well-known example of this coordinated control that drives the transition from the G2 to the M phase.
M cyclin...
Phase Transitions01:21

Phase Transitions

A phase transition is the process in which a substance changes from one state of matter to another, like from a solid to a liquid, liquid to gas, or vice versa, at a specific temperature and under given pressure conditions. This change is spontaneous and is affected by alterations in temperature and pressure. These parameters impact the strength of the forces between molecules (intermolecular forces) in the substance.During a phase transition, both the initial and final phases of the substance...
Transition State Theory01:25

Transition State Theory

Transition-state theory, also known as activated-complex theory, provides a molecular-level explanation of reaction rates in both gas-phase and solution-phase reactions. It extends earlier kinetic models by considering the formation of a short-lived, high-energy configuration during a reaction.The progress of a chemical reaction can be represented using a reaction profile, which plots potential energy against the reaction coordinate. As two reactant molecules approach one another, their...
Transition Zone01:28

Transition Zone

The transition zone in concrete is a critical area where aggregate meets cement paste, marked by a distinct porosity and weakness compared to the surrounding material. The adhesion around the aggregates is primarily due to Van Der Waals forces. The voids within this zone influence its robustness; initially, it is less durable than the surrounding bulk mortar due to larger voids. Initially, when concrete is compacted, a higher water-cement ratio near the aggregates leads to the formation of...