Related Experiment Videos
Stresses within porcelain veneers and the composite lute using different preparation designs
K G Seymour1, G P Cherukara, D Y Samarawickrama
1Department of Adult Oral Health, St. Bartholomew's and the Royal London School of Medicine and Dentistry, Queen Mary and Westfield College, Whitechapel, London E1 2AD, England. k.g.seymour@mds.qmw.ac.uk
Purpose:
The purpose of this study was to investigate compressive and tensile stresses in porcelain and composite at the labial marginal region of porcelain veneer restorations using chamfer, shoulder, or knife-edge labial margin designs with labial window or incisal overlap incisal preparation designs.
Methods:
Porcelain veneer models were constructed and loaded with (1) a 200-N, 45 degrees palatal load to simulate functional loading, and (2) a horizontal labial loading of 200 N to mimic trauma. Maximum tensile and compressive stresses were recorded within the labial marginal region of both porcelain and composite lute.
Results:
Under the 45 degrees palatal load, stresses within the palatal marginal porcelain were chiefly compressive, and stresses for the knife-edge designs as much as 42% less than for shoulder designs. Incisal overlap preparations were generally associated with less compressive stress within both porcelain and composite than the window preparation. When a labial load was applied, tensile stresses were as much as 25 times greater for the chamfer and shoulder designs compared with the knife-edge design. Labial loading also resulted in an increase in tensile stresses within the composite lute, and stresses were again lowest within the knife-edge margin design.
Conclusions:
Under the limitations of this study, using the incisal overlap preparation, porcelain veneers with knife-edge labial margins could better sustain occlusal loading without fracture. J Prosthodont 2001;10:16-21.