Carbonyl sulfide derived from catalytic oxidation of carbon disulfide over atmospheric particles

The formation of carbonyl sulfide (COS) by catalytic oxidization of carbon disulfide (CS2) over atmospheric particle catalysts was explored through FT-IR, MS (mass spectrometry), and a fixed-bed stainless steel reactor. Also the crystallizing conditions and specific surfaces (areas) of the catalysts were investigated by means of X-ray diffraction (XRD) and BET. Some oxides such as CaO, Fe2O3, Al2O3, and SiO2 were investigated under the conditions similar to the atmospheric particles as a comparison. The results showed that atmospheric particles and the oxide catalysts exhibited considerable oxidizing activity for CS2 at ambient temperature to form COS. Elemental sulfur as well as COS was one of the main products; even CO2 could be produced by a secondary reaction on some catalysts. Among the catalysts, CaO showed the strongest catalytic activity for oxidizing CS2. The catalytic activities of Fe2O3 and Al2O3 decreased considerably as compared with CaO, and SiO2 had the weakest catalytic activity. Atmospheric particles' catalytic activity is between Fe2O3's and Al2O3's. The atmospheric particles we collected mainly consist of Ca(Al2Si2O8).4H2O, which is also the main component of cement. COS, the main product, is formed by the catalytic oxidizing reaction of CS2 with adsorbed "molecular" oxygen overthe catalysts' surfaces. The concentration of adsorbed oxygen over catalysts' surfaces may be the key factor contributed to the oxidizing activities. This paper first revealed that CS2 could be catalytically oxidized over atmospheric particles to form COS. It induced that this reaction may be another important source of atmospheric COS from CS2.