Numerical simulation of a natural gradient tracer experiment for the natural attenuation study: flow and physical...

Results are presented for numerical simulations of ground water flow and physical transport associated with a natural gradient tracer experiment conducted within a heterogeneous alluvial aquifer of the Natural Attenuation Study (NATS) site near Columbus, Mississippi. A principal goal of NATS is to evaluate biogeochemical models that predict the rate and extent of natural biodegradation under field conditions. This paper describes the initial phase in the model evaluation process, i.e., calibration of flow and physical transport models that simulate conservative bromide tracer plume evolution during NATS. An initial large-scale flow model (LSM) is developed encompassing the experimental site and surrounding region. This model is subsequently scaled down in telescopic fashion to an intermediate-scale ground water flow model (ISM) covering the tracer-monitoring network, followed by a small-scale transport model (SSM) focused on the small region of hydrocarbon plume migration observed during NATS. The LSM uses inferred depositional features of the site in conjunction with hydraulic conductivity (K) data from aquifer tests and borehole flowmeter tests to establish large-scale K and flow field trends in and around the experimental site. The subsequent ISM incorporates specified flux boundary conditions and large-scale K trends obtained from the calibrated LSM, while preserving small-scale K structure based on some 4000 flowmeter data for solute transport modeling. The configuration of the ISM-predicted potentiometric surface approximates that of the observed surface within a root mean squared error of 0.15 m. The SSM is based on the dual-domain mass-transfer approach. Despite the well-recognized difficulties in modeling solute transport in extremely heterogeneous media as found at the NATS site, the dual-domain model adequately reproduced the observed bromide concentration distributions. Differences in observed and predicted bromide concentration distributions are attributed to aquifer heterogeneity at the decimeter (dm) and smaller scales. The calibrated transport parameters for the SSM (i.e., 1:7 for the ratio of mobile-to-total porosity; 2.5 x 10(-3) day-1 for the mass-transfer coefficient; 1 m for longitudinal dispersivity; and 0.1 m for transverse dispersivity) are consistent with separate numerical simulations of two earlier tracer experiments at the site. The multiscale modeling approach adopted in this study permits the incorporation of both large-scale geologic features important for flow simulation and small-scale heterogeneities critical for transport simulation. In addition, the dual-domain transport model provides a foundation for multispecies reactive transport modeling studies of natural attenuation of hydrocarbons during NATS.