Complex-induced proximity effects: the effect of varying directing-group orientation on carbamate-directed lithiation

K M Gross1, P Beak

  • 1Contribution from the Department of Chemistry, Roger Adams Laboratory, University of Illinois at Urbana-Champaign, 61801, USA.

Related Concept Videos

Regioselectivity of Electrophilic Additions to Alkenes: Markovnikov's Rule02:17

Regioselectivity of Electrophilic Additions to Alkenes: Markovnikov's Rule

If a set of reactants can yield multiple constitutional isomers, but one of the isomers is obtained as the major product, the reaction is said to be regioselective. In such reactions, bond formation or breaking is favored at one reaction site over others.
The hydrohalogenation of an unsymmetrical alkene can yield two haloalkane products, depending on which vinylic carbon takes up the halogen. However, one product usually predominates, where hydrogen adds to the vinylic carbon bearing the...
Regioselectivity and Stereochemistry of Acid-Catalyzed Hydration02:34

Regioselectivity and Stereochemistry of Acid-Catalyzed Hydration

The rate of acid-catalyzed hydration of alkenes depends on the alkene's structure, as the presence of alkyl substituents at the double bond can significantly influence the rate.
Regioselectivity and Stereochemistry of Hydroboration02:36

Regioselectivity and Stereochemistry of Hydroboration

A significant aspect of hydroboration–oxidation is the regio- and stereochemical outcome of the reaction.
Hydroboration proceeds in a concerted fashion with the attack of borane on the π bond, giving a cyclic four-centered transition state. The –BH2 group is bonded to the less substituted carbon and –H to the more substituted carbon. The concerted nature requires the simultaneous addition of –H and –BH2 across the same face of the alkene giving syn stereochemistry.
Inductive Effects on Chemical Shift: Overview01:27

Inductive Effects on Chemical Shift: Overview

The protons in unsubstituted alkanes are strongly shielded with chemical shifts below 1.8 ppm. Methine, methylene, and methyl protons appear at approximately 1.7, 1.2 and 0.7 ppm, while the proton signal from methane appears at 0.23 ppm. An electronegative substituent, such as chlorine, withdraws the electron density from the protons, increasing their chemical shift. Progressive substitution of the hydrogens in methane by chlorine shifts the proton signals increasingly downfield, to 3.05 ppm in...