PAH emission from the incineration of three plastic wastes

A batch-type, controlled-air incinerator was used for the treatment of polyvinyl chloride (PVC), high-density polyethylene (HDPE), and polypropylene (PP) plastic wastes. The concentration and composition of 21 individual polycyclic aromatic hydrocarbons (PAHs) in the raw wastes, flue gas (gas and particle phases), and ash were determined. Stack flue-gas samples were collected by a PAH stack-sampling system. Twenty-one individual PAHs were analyzed primarily by a gas chromatograph/mass spectrometer (GC/MS). The CO concentration correlated well with the total PAH (R2 > .89), and thus can be used as a surrogate indicator for PAH emission. Excess amounts of air supply in the incineration of plastic wastes could decrease not only the concentration of the PAHs in the bottom ash but also the emission factor (EF) of the total PAH in the stack flue gas. Of the three plastic wastes, HDPE was found to have the highest mean EF of the total PAHs (462.3 mg/kg waste) from the stack flue gas. Incinerating PVC would result in a higher EF of PAHs (195.4 mg/kg waste) in the bottom ash. When PVC plastic wastes were incinerated, higher-ringed PAHs constituted a larger percentage in the bottom ash as compared to those from PP and HDPE plastics. By judging the output and input (O/I) ratio of the PAHs from the incineration trials of plastic wastes, the PAHs involved in incineration of three plastic wastes were almost entirely destroyed; and a low residual amount between 0.00018 and 0.00032 remained in the emission.