Remediation of TCE contaminated soils by in situ EK-Fenton process

The treatment performance and cost analysis of in situ electrokinetic (EK)-Fenton process for oxidation of trichloroethylene (TCE) in soils were evaluated in this work. In all experiments, an electric gradient of 1V/cm, de-ionized water as the cathode reservoir fluid and a treatment time of 10 days were employed. Treatment efficiencies of TCE were evaluated in terms of the electrode material, soil type, catalyst type, and catalyst dosage and granular size if applicable. Test results show that graphite electrodes are superior to stainless steel electrodes. It was found that the soil with a higher content of organic matter would result in a lower treatment efficiency (e.g. a sandy loam is less efficient than a loamy sand). Experimental results show that the type of catalyst and its dosage would markedly affect the reaction mechanisms (i.e. "destruction" and "removal") and the treatment efficiency. Aside from FeSO4, scrap iron powder (SIP) in the form of a permeable reactive wall was also found to be an effective catalyst for Fenton reaction to oxidize TCE. In general, the smaller the granular size of SIP, the lower the overall treatment efficiency and the greater the destruction efficiency. When a greater quantity of SIP was used, a decrease of the overall treatment efficiency and an increase of percent destruction of TCE were found. Experimental results have shown that the quantity of electro-osmotic (EO) flow decreased as the quantity of SIP increased. It has been verified that the treatment performances are closely related to the corresponding EO permeability. Results of the cost analysis have indicated that the EK-Fenton process employed in this work is very cost-effective with respect to TCE destruction.