The effects of pH and surface composition on Pb adsorption to natural freshwater biofilms

Two dominant variables that control the adsorption of toxic trace metals to suspended particulate materials and aquatic surface coatings are surface composition and solution pH. A model for the pH-dependent adsorption of Pbto heterogeneous particulate surface mixtures was derived from experimental evaluation of Pb adsorption to laboratory-derived surrogates. The surrogate materials were selected to represent natural reactive surface components. Pb adsorption to both the laboratory surrogates and natural biofilms was determined in chemically defined solutions under controlled laboratory conditions. Pb adsorption was measured over a pH range of 5-8, with an initial Pb concentration in solution of 2.0 microM. The surface components considered include amorphous Fe oxide, biogenic Mn oxide produced by a Mn(II) oxidizing bacterium (Leptothrix discophora SS-1), Al oxide, the common green alga Chlorella vulgaris, and Leptothrix discophora SS-1 cells. A linearization of Pb adsorption data for each adsorbent was used to quantify the relationship between Pb adsorption and pH. The parameters for individual adsorbents were incorporated into an additive model to predict the total Pb adsorption in multiple-adsorbent natural surface coatings that were collected from Cayuga Lake, NY. Pb adsorption experiments on the natural surface coatings at variable pH were utilized to verify the additive model predictions based on the pH dependent behavior of the experimental laboratory surrogates. Observed Pb adsorption is consistent with the model predictions (within 1-24%) over the range of solution pH values considered. The experimental results indicate that the combination of Fe and biogenic Mn oxides can contribute as much as 90% of Pb adsorbed on Cayuga Lake biofilms, with the dominant adsorbent switching from Mn to Fe oxide with increasing pH.