Analysis of temporal shear stress gradients during the onset phase of flow over a backward-facing step

M A Haidekker1, C R White, J A Frangos

  • 1University of California, San Diego, Department of Bioengineering, La Jolla 92092-0412, USA.

Related Concept Videos

Shearing Stress01:18

Shearing Stress

Shearing stress, denoted by the Greek letter tau (τ), is stress caused by forces acting transversely on an object. These forces create internal ones within the entity in the plane where the external forces are applied. The resultant of these internal forces is the shear in the section.
The average shearing stress can be calculated by dividing the shear by the area of the cross-section.
Stress: General Loading Conditions01:15

Stress: General Loading Conditions

To grasp the intricacy of real-world conditions where multiple loads are applied simultaneously to a structure, one might visualize a section passing through a specific point within a body, aligned parallel to the xy plane. This section is subjected to various forces, including original loads, normal forces, and shearing forces.
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes.
Thin-Walled Hollow Shafts01:15

Thin-Walled Hollow Shafts

In analyzing a thin-walled hollow shaft subjected to torsional loading, a segment with width dx is isolated for examination. Despite its equilibrium state, this segment faces torsional shearing forces at its ends. These forces are quantitatively described by the product of the longitudinal shearing stress on the segment's minor surface and the area of this surface, leading to the concept of shear flow. This shear flow is consistent throughout the structure, indicating a uniform distribution of...
Principal Stresses01:24

Principal Stresses

The graphical depiction of normal and shearing stress equations is represented by a circle, demonstrating the interplay between these stresses under different angular conditions. The center of this circle C, located on the vertical axis, represents the average normal stress, while its radius shows the range of stress variations. At points A and B, where the circle intersects the horizontal axis, the maximum and minimum normal stresses are observed, occurring without shearing stress. These...
Principal Stresses: Problem Solving01:15

Principal Stresses: Problem Solving

When analyzing two planes intersecting at right angles under the influence of shearing, tensile, and compressive stresses, it is essential to identify principal planes, maximum shearing stress, and principal stresses. To find the principal planes, apply a formula that equates them to twice the shearing stress divided by the difference between tensile and compressive stresses.
Navier–Stokes Equations01:28

Navier–Stokes Equations

For incompressible Newtonian fluids, where density remains constant, stresses show a linear relationship with the deformation rate, defined by normal and shear stresses. Normal stresses depend on the pressure exerted on the fluid and the rate of deformation in specific directions, which determines how fluid flows under varying pressures. Shear stresses, on the other hand, act tangentially across fluid layers. They explain how adjacent fluid layers slide relative to one another, connecting...